Welcome to our world exploring the Historical, Political and Technological aspects of Locks, Keys and Safes

Results 1 to 5 of 5

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Oct 2009
    Location
    Cleveland, Ohio USA
    Posts
    1,433
    Country: United States

    Default Keys for Perreymond Brevete

    Almost finished with these keys. I knew they would be difficult, and I surely wasn't disappointed. The smallest is about 2-1/2" and 5" on the big one. Each key was made from a single piece of steel. The large key started out as a 7" x 2-1/2" X 3/4" chunk. To hold the steel in the lathe between centers, extra length was needed at both ends. So the steel was laid out with dye and center drilled at each end. Also drilled for the pin. Next step was cutting out much of the excess with the band saw and some chain drilling. At each end enough was cut off to fit on a lathe dog. Now set up on the lathe, the turning can be and should be completed. The extra length at the bit end should also be turned down round to the same diameter as the shaft. This helps to properly establish the round area under the bit that is filed down by hand.
    Attached Thumbnails Attached Thumbnails IMG_20180325_111559183_960x1280.jpg   IMG_20180325_112633186_960x1280.jpg   IMG_20180325_112706638_1280x960.jpg  

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •