5 Attachment(s)
Corbin "SP" CO. Padlock....
I'm sure all have seen this padlock. I has is for a long time trying to impression this padlock. Also was hard to pick because these are ball bearing pins. I just got to point by looking at other padlock on eBay that look like my until I found one key that has key cut stamp. Thinking about it and went a head to cut the key by 0-9-0-9-0-9. Surprise me that key work. Now got a working key to open this padlock. I think that most of Rail Road padlock that look like my ma come in key code 0-9-0-9-0-9. I have see three or more of it on eBay same cut.....Tmothy....
Corbin "SP" CO. Padlock....
Mercury
You gave good information about ball bearing. As talking about impression it was hard as don't show to much mark to see. The only reason this one so hard because of the way it set the pins up. I have done a few padlock that does have ball bearing in it was not too bad to do it but take time. I'm just glad I finally got this padlock with working key....Timothy.....
Corbin "SP" CO. Padlock....
Candado 3
Yes is it 1001DA for six pins The first time was thinking as five pins by using five pins key blank but found out the first one was a no cut "0" with five cut 9-0-9-0-9. Need to feel your pins by using the pick tool to be sure using six pins key blank.
HUW
They do have them in Corbin cylinder lock, Russwin lock also have it. Don't know of any other lock manufactured use it ..Timothy.....