vBulletin Message
Invalid Forum specified. If you followed a valid link, please notify the administrator
Thanks - the finish is achieved with bladed end of a panel pin hammer over the worked areas of the key to soften the transition from the raw cast area, then buff on a bench mounted wire wheel...
A collector showed me a Marr partner lock similar to this, in full working order. I do not remember if it had a detector. It was years ago, the collector is now deceased and I do not know who now has...
The lock says 'Made in Switzerland'; the key which came with it is marked 'Chatwood'. The lock looks very similar to some Kromer wallsafe locks, including provision (not used onin this lock) for...
I can no longer remember where I found the cylinder shown on the right. It has evoked some interest at shows, as it is an early cylinder without the steel cover. Additionally, it has only 2 fixing...
This is the apparently uncommon Sidleen nightlatch: has anyone else seen one in service?
Any clues as to a date for that ? I assume it must be fairly late as they have moved onto offering 7 lever as the 'base' model which are generally the hardest to find examples of (the 9, 11, and 15 I...
Hobbs