Activity Stream

If you dial it like a 3 wheel lock when changing the combination, it will then open like that and sometimes customers set them like that if they also...

I am hoping that someone can answer that question. No problem in finding a change key. Still hoping to find a couple of replacement dials.

I find this fascinating. Did they make a 4-wheel lock such that it could easily and intentionally be "down-converted" to a three-wheel lock?

Done you informed me of blackhawk several years ago,a lot of sites popped up so i left it alone i took your recommendation and joined today,all...

Yes Nathan, Roger Weitzenkamp is the proprietor; $59.00/yr web and phone, highly recommended by yours truly, demo on their website:...

thank you,Sir appreciate the info When i have went to blawkhawk in the past it referred me to lockcodes.com is this the same ? it also gave me...

Of the three codes I could read in marker: R3157 not found GN7211 cuts 1144 on Ilco 1004M DSD 47 GN7599 cuts 6544 on Ilco 1004M DSD 47 ...

You were correct, it was a rivet. Now drilled out, hinge tapped & oversized screw made. Just got to get safe body upstairs now. Hopefully 2 people...

Gary, as usual you are correct on the 4 wheels. the reason i said 3 was because i have the 3 numbers for the combo. However i just checked and when i...

It is a 4 wheel not a 3 wheel 7L51 model number.

Thanks for the information, I ll try that tomorrow. I can make a larger screw on my lathe & tap the hinge with a larger thread afterwards.

Most unusual. Looks like it's a rivet in the middle. If so you could either drill it right through or just cut away the countersink on the outside...

I still can’t see any sign of a screw head, it looks more like some sort of press fit pin. It is a very early Milner. The diameter on the outside...

Oh, I see that the middle screw goes in the opposite direction. Will the door then lift out of the bottom pivot without removing the hinge?

There are usually 3 screws on the hinge. Tap and scrape and it should be there.

I have a few too, what I have not seen and would be interested to see is a master keyed example.

Pete You right about trying to find Flat blank key #94. I have see it for a long time but have not found anyone selling those blank. Can't believe...

Agreed, 94 is the better choice but it doesn't appear in Ilco Key Blanks MSRP List Price, 9/1/18 indicating likely discontinued, so if you find any...

Nice Lock as what Pete said about key 1031 there also key look almost like what Pete send per attached but this is Brass key #94.....Timothy.....

Looks like that cylinder likely uses the original Yale No. 1 pin tumbler blank which was flat with a trefoil bow and in use until 1882, see thumbnail...